4/25/2021 0 Comments Bartender Ultra Light
Clicking that button will offer a variety of commands, including Run Calibration.History Company Culture at EIM Careers Be a Label Expert Close Contact Us infosamples Technical Support Close.
Bartender Ultra Light Driver Works WellThis Windows-compatible driver works well for printing from BarTender, Microsoft Word, and most any other Windows program that can be printed from.If given the option between installing an EPL or ZPL version of your printer, we commonly recommend ZPL. Click Next. Note: If Windows automatically installed your printer upon connection, it is likely to have used the Zebra or other manufacturer driver, and we recommend following the steps above to re-install or replace your printer driver with the Seagull version. As well as the ability to send helpful commands to the printer such as Run Calibration and Reset to Factory Defaults. Regardless of the way you access the driver settings you will bring up another pop-up where printer settings can be adjusted. Some, but not all, of the settings you can adjust are listed below starting with the most commonly used. Often, the default heat setting is not sufficient to gain a quality print, especially on polyester labels. Fortunately, Seagulls printer driver allows you to adjust the heat under the Options tab in Document Properties (See previous page on how to access the driver settings). Note: You will have to uncheck the box that reads Use Current Printer Settings to be able to adjust the darkness slider. EIM also recommends using the Absolute option rather than Relative for consistent printing. This will most often be used to try to solve calibration or print quality issues. The Seagull Printer Driver allows you to Use current printer settings with your label format, or over-write them with new ones. This means the printer looks for gaps between labels to know where to print. If you have specially made labels with a mark on the back for sensing, you would choose the Mark Sensing option. Under the Print Method menu, you can choose Thermal Transfer or Direct Thermal. If you are using print ribbon, then your print method is Thermal Transfer. If you are printing without ribbon on special Direct Thermal labels, then Direct Thermal would be your print method. When a printer is properly calibrated and ready to print, the green light on top should be solid, and pressing the feed button should feed exactly one label at a time from your printer. If the printer does not feed just one label, it likely needs to be re-calibrated. This is done by various Flash Sequences that are sent by holding the top button down for a certain amount of time. To send a calibrate command to the printer, hold the feed button down on the printer. If you release the button after the green light flashes twice, a few labels will feed from the printer and it will re-calibrate to your label stock.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |